Your trusted plumber in Leicester

Inspection of boiler and heating components, fault diagnosis, repair or replacement of faulty parts, testing system pressure and safety controls, recommissioning the boiler.

When you need it. Boiler won't fire up, producing no heat, making unusual noises, leaking water, or showing fault codes.

Before you get in touch. Note any error codes displayed. Check if the system has power and the thermostat is set correctly.

Locating source of leak, isolating water supply where possible, temporary or permanent repairs to pipes or fittings, drying affected areas, identifying damage.

When you need it. Visible water spray or drips from pipes, ceiling stains, sudden wet patches on walls or floors, water pooling indoors.

Before you get in touch. Locate your stopcock and turn off water supply if the leak is severe. Note where water is coming from.

Identifying blockage location using inspection cameras if needed, removing debris using rods or suction, flushing the drain clean, testing water flow.

When you need it. Water drains slowly or not at all, gurgling sounds from drains, bad smells from pipes, sewage backing up.

Before you get in touch. Note which drains are affected and when the problem started. Avoid pouring more water down.

System design and layout, installation of boiler, radiators, pipework and controls, commissioning and safety checks, balancing radiators for even heat distribution.

When you need it. Installing new heating in an unheated property, replacing an old or broken system, extending system to new rooms.

Before you get in touch. Measure rooms that need heating. Check available space for boiler. Have floor plans or photos handy.

Removing old suite, preparing walls and floors, installing bath or shower, fitting toilet and basin, connecting water supply and waste, tiling and sealing.

When you need it. Bathroom suite is cracked or stained, fixtures leak or don't work, want to update appearance or layout.

Before you get in touch. Decide on layout and products. Check access to water supply and waste pipes. Have measurements ready.

Repair or replacement of taps, valves, stopcocks, waste traps and pipe fittings, leak detection, small bore pipe work, fixing or replacing damaged sections.

When you need it. Tap won't stop dripping, pipes are leaking, fixtures are loose or broken, water pressure is low.

Before you get in touch. Identify which fixture is faulty. Turn off water if actively leaking. Take photos of damage if visible.